POLY
WATER TANKS
Delivery & Installation of Poly Water
Tanks
It is not the responsibility of Poly Water Tanks drivers to lift
and place tank in it’s final installed position.
Our driver will unload the tank from the truck or trailer and place
it beside the truck only it is the responsibility of the purchaser
to lift tank into its final installed position.
Site Preparation & Installation Instructions:
* The tank is made of polyethylene. It must be handled with care.
Avoid sliding on rough & sharp surfaces. Lift the tank when
moving into position.
* Tank site must be smooth & level, and be cleared of all rocks,
stones sticks and sharp objects that may damage base of tanks.
* Site must be solid and compacted ground especially if fill is
to be used.
* Tanks can be placed on a level concrete slab with a smooth finish.
Avoid rough screeding.
* Concrete slab must be level reinforced and thick enough with diameter
greater than tank to support weight of tank when full. If in doubt,
consult engineer.
* Tanks can be placed on level bed of packing sand 100mm thick and
retained 300mm greater in diameter to avoid undermining from wind,
water or vermin
* Tank stands can be used but must be designed by a consulting engineer.
* A 300mm flexible pipe should be installed after the ball valve
tap to minimise strain on tank and fittings.
* Tank overflow should be piped away from the tank.
* Slimline tanks must always be placed on level concrete slab.
* Slimline tanks are delivered with clear plastic wrapping. This
wrapping must not be removed
until the tank is fully installed in its final position.
Rotational Moulders Pty Limited ABN 45877325953
13 Ketch Close Fountaindale NSW 2258 Australia
Phone: 02 43885700 Fax: 02 43883927
Email: info@polywatertanks.com.au
Call
Enviro-Friendly today on (02) 6282 6266, and find out how we can
help you
"Save water, save energy, save
money, and save the environment."
For
enviro-friendly tips and news, be sure to
and please, tell your friends about us!
|